About the head of uArmⅠ v1.1

From now on, there are two kinds of choices for the head of the robot arm.

One is a sucker and the other is a servo for installing robot gripper on it. You can see two of them in the following picture.
IMG_9652

On the other hand, there are also two ways to install the head to the robot arm. One is to face down and the other is to face forward. The following picture shows the parts for different install ways.
IMG_9659

Install the sucker to the head of the robot arm.
IMG_9666 IMG_9665

Install the servo motor to the head of the robot arm.
IMG_9678 IMG_9694

The second way for installing.
IMG_9670 IMG_9675

3 Comments

  • Urill December 15, 2013 at 11:02 am

    Nice work :)

    The robot arm is described as “open source” on your homepage. When the laser cutting design will be availble for public? I can’t wait to build one for myself.

    Reply
    • ufactory December 16, 2013 at 5:24 am

      Hi there,

      We are making an improvement of the design recently. And will release the design of it soon after we finish this project.

      Best Regards,
      UFactory Team

      Reply
      • saeadanwari February 20, 2014 at 11:31 pm

        Hi Ufactory team,
        Can you please a bit specify ‘soon’? how long will be that?

        Reply

Leave a Comment